Projector
Portable Projector
VT700/VT695/VT595/VT590/VT491/VT59/VT49
High-performance, cost-effective projector offers easy,
multifunction operation perfect for business and education.
- DVI input connector (DVI-I) and HDCP compatible (VT700 / VT 695 and VT595 only)
- Quick start & quick cool down
- Auto Vertical Keystone Correction (VT700 / VT695 and VT595 only)
- Wall Colour Correction
- Very quiet operation
- Built - in speaker (5W for VT700 / VT695 / VT595 and 1 W for VT590 / VT 491 / VT59 / VT49)
- Security Function
From Digital Cinema to Mobile Convenience - NEC Proiector is the Best Solution
- DVI in put connector (DVI-I) and HDCP compatible (VT700 / VT695 and VT595 only)
With the DVI-I input connector (DVI-I) , the projector can display digital RGB images. By using the DVI-RGB adapter, analogue RGB signals can be connected from two computers. The DVI-I input connector supports HDCP.
- Quick start & quick cool down
Eight seconds after turning on the power, the projector is ready to display PC or video images. Powering down, the fans stop 30 seconds after turning off the power from the remote control or cabinet control panel. The projector can be stored immediately after powering down.
The main power for the projector can be turned off by either pressing the main power switch or by unplugging the power cable, even during the cool down period after the projector is turned off.
- Auto Vertical Keystone Correction adjusts the trapezoidal distortion to correct the projected image (VT700 / VT695 and VT595 only)
if the position of the screen is too high or low, the projector must be installed at an angle, resulting in trapezoidal distortion of the projected images. The acceleration sensor built into the main unit senses the inclination of the unit in the vertical direction and then corrects for any trapezoidal distortion in the projected image automatically to project square images(+/- 30 degrees from the projection angle). Projector setup is quick and easy as manual correction is not necessary. Manual vertical Keystone Correction is available on the VT590/VT491/VT59/VT49.
- Wall Colour Correction for vivid images even without a screen
Without a screen, projected images are affected because of the colour of the wall or blackboard you are projectiing on to.The built-in colour correction for projecting images on a coloured wall or blackboard in this projector means that the colour tones of the projected image is approximate to those that are projected on to a white screen. The following eight colour options are avilable : blackboard, blackboard (grey), light yellow, light green. light blue, sky blue, light rose, and pink.
- Very quiet operation in Eco Mode
Eco mode operation drops projector noise to 25 dB for very quiet operation (VT59/VT49) and extends the lamp replacement period up to a maximum of 4000 hours (VT59/VT49). In this mode, total cost of ownership can be effectively reduced. The projector can be put in to Eco Mode very easily with a button on the remote control.
- Auto start
Turns the projector on automatically when the power cable is inserted into an active power outlet. This eliminates the need to use the POWER button on the remote control or projector cabinet. " To use Auto Start, first set the main power switch to "On" before plugging in the power cable.
- Bulit-in speaker for integrated audio solutions
The built-in monaural speaker (5W for VT700/VT695/VT595 and 1W for VT590/VT491/VT59/VT49)on the main unit outputs audio from computer, video, and S-video inputs.
- Security function prevents unauthorized use or theft
Password access prevents unauthorized use of the projector. Once the security function is activated, a message requesting the password is displayed when the power of the main unit is turned on. li is not possible to project an image unless the correct password is entered.
- Carrying handle for easy transport
The supplied carrying handle can be installed on the main unit for easy transportation.(VT700/VT695/VT595/VT590/VT491 only)
- Remote Mouse Operation
You can use the supplied wireless remote control and the optional remote mouse receiver to control your PC from acros the room. The optional remote mouse receiver (NP01MR) supports almost any PC with a USB connection.
- High Altitude Mode
The high altitude mode, allows operation of the prejector in low air pressure / high altitudes, eg.venues located over 1,600 m above sea level.(VT700)
- Supports component signals
- Preset function for setting and storing your favorite colour settings
- HDTV(1080i, 720p) and SDTV (576p, 480p) compatibility
- Short focal length lens
| Model |
Resolution |
Brightness |
Zoom |
computer Input |
Speaker |
| VT700 |
XGA
|
3000 ANSI Iumens
|
Manual Zoom
|
Analog with DVI-I
|
5W
|
| VT695 |
XGA |
2500 ANSI Iumens |
Manual Zoom |
Analog with DVI-I |
5W |
| VT595 |
XGA |
2000 ANSI Iumens |
Manual Zoom |
Analog with DVI-I |
5W |
| VT590 |
XGA |
2000 ANSI Iumens |
Manual Zoom |
Analog |
1W |
| VT491 |
SVGA |
2000 ANSI Iumens |
Manual Zoom |
Analog |
1W |
| VT59 |
XGA |
1600 ANSI Iumens |
Manual Zoom |
Analog |
1W |
| VT49 |
SVGA |
1600 ANSI Iumens |
Digital Zoom |
Analog |
1W |
Specifications
| Model Name MultiSync V595 |
|
| Lens |
Manual Focus |
(Range 1.5 to 1.8)(f=18.9mm to 22.7mm) |
| Zoom |
Manual (Ratio : 1.2) |
| Light Output |
2000 ANSI Iumens (Approx. 80% in Eco Mode) |
| Contrast Ratio |
600 : 1 |
| Fan Noise |
Normal Mode |
34dB |
| Eco Mode |
29dB |
| Image Size |
21 to 300 inches |
| Projection Angle |
8.3 to 8.6 (Tele).9.9 to 10.3 (Wide) |
Scan Rate |
Horizontal |
15kHz to 100kHz (RGB : 24kHz or over) |
| Vertical |
50Hz to 120Hz |
| Control Terminals |
RS-232C |
| Built - In Speaker |
5W Monaural |
| Power Consumption |
Normal Mode |
270W |
| Eco Mode |
220W |
| Standby Mode |
9W |
| Input Current |
3.1/1.3A(100/240V AC) |
| Power Requirement |
100 - 240 V AC (50/60Hz) |
| Requlations |
For United States*5 |
UL Approved(UL 60950-1) Meets FCC Class B Requirements |
| For Canada *5 |
UL Approved(CSA 60950-1), Meets DOC Canada Class B Requirements |
For Australia/
New Zealand *5 |
Meets IEC60950-1 , Meets AS/NZS CISPR.22 Class B |
| For China *5 |
GB4943 , GB9254 , GB17625.1 |
| For Europe |
Meets EMC Directive(EN55022 , EN55024, EN61000-3-2, EN61000-3-3),Meets Low Voltage Directive(EN60950-1,TUV GS Approved) |
| Net Weight |
3.0kg |
| Dimensions(WxHxD) |
309mm x 112mm x 258mm (Not Including Protrusions) |
Top of this page
